Home / Knowledge hub / Guide
Guide

Sludge blanket level measurement in clarifiers

The sludge blanket in a clarifier is easy to misjudge by sight. Measuring the interface gives you a number to control with.

Why measure the sludge blanket

Sludge settles at the bottom of a clarifier and must be drawn off before it builds up and carries over into the clear water. Discharging on a fixed timer or by operator judgement can mean removing sludge too early, too late, or with too much water.

How an ultrasonic sludge level meter works

A submerged ultrasonic sensor sends a pulse down through the water and times the echo from the sludge boundary. The transmitter converts the echo time into interface depth and reports it continuously, without sampling.

The HYKO® SLM-120 sensor measures up to 10 m with accuracy better than 0.3%, and the transmitter adds a display, 4–20 mA outputs, relays, data logging and trend curves.

Installation tips

From measurement to automation

With the level in the PLC, the discharge valve can open at a high setpoint and close at a low one, so sludge removal follows the real blanket. Trend curves show how the layer behaves over time and help tune settings.

Adding density

Where you also need the concentration of the sludge being withdrawn, an inline ultrasonic sludge density meter such as the ENV200 shows how thick the discharge is.

Common questions

Can the sensor be used without the transmitter?

Yes. The sensor has an RS485 Modbus output and can connect directly to a PLC or gateway.

Does it need sampling?

No. It measures the interface continuously.

Related instruments

HYKO® SLM-120ENV200

Related case studies

Related services

Automation & IntegrationAnnual Maintenance Contracts (AMC)

Not sure which is right for you?

Tell us your application and we will recommend an instrument.

Related searches: sludge blanket level meter, clarifier sludge level measurement, sludge interface level, automatic sludge discharge, ETP STP sludge monitoring.